FUEL SYSTEM 12-3
CLEANING AND INSPECTION
If the fuel strainer is dirty with sediment, fuel will not flow
smoothly and loss in engine power may result. Clean the fuel
strainer with compressed air.
INSTALLATION
Install the fuel tank and fuel valve in the reverse order of
removal. Pay attention to the following points:
• Install the fuel valve and fuel hose.
# Fuel valve mounting bolt: 5 N·m (0.5 kgf-m, 3.5 lb-ft)
INSPECTION AFTER INSTALLATION
• Fuel hose routing (!19-21)
• Fuel leakage (!2-21)
CAUTION
Replace the O-ring
1 with a new one to prevent fuel
leakage.
To Next Page
Loading...
