Suzuki RM-Z250 - Disc Plate Replacement; Rear Sprocket Replacement

15-10 FRONT AND REAR WHEELS
• Install the dust seals and apply grease to their lips.
NOTE:
When installing the dust seal, place the manufacturer’s code
indicated side of the dust seal outside.
" 09913-70210: Bearing installer set
Oil seal: # 42 Attachment
$ 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
DISC PLATE REPLACEMENT
• Remove the disc plate.
• Apply THREAD LOCK SUPER to the bolts.
% 99000-32130: THREAD LOCK SUPER “1360”
• Tighten the bolts to the specified torque.
& Disc plate bolt: 25 N·m (2.5 kgf-m, 18.0 lb-ft)
REAR SPROCKET REPLACEMENT
• Remove the rear sprocket.
NOTE:
Install the rear sprocket as the letter on the sprocket surface
faces outside.
• Tighten the nuts to the specified torque.
& Rear sprocket nut: 30 N·m (3.0 kgf-m, 21.5 lb-ft)