10-12 TRANSMISSION AND CRANKSHAFT
INSTALLATION
• Press the new bearings with the special tool.
" 09913-70210: Bearing installer set
Bearing
1: $ 52 Attachment
Bearing
2,
8: $ 40 Attachment
Bearing
3,
6: $ 62 Attachment
Bearing
4: $ 32 Attachment
Bearing
5: $ 47 Attachment
Bearing
7: $ 42 Attachment
Bearing
9: $ 15 Attachment
• Press the bearing
0 with the appropriate steel rod.
NOTE:
* Press the bearings (
2,
4,
5,
8) into the crankcase, so that
the stamped mark side faces inside of the crankcase.
* Press the bearings (
9,
0) into the crankcase, so that the
stamped mark side faces outside of the crankcase.
NOTE:
* Press the bearings (
1,
3 and
6) into the crankcase, so that
the stepped side
A faces inside of the crankcase.
* Press the bearing
7 into the crankcase, so that the sealed
side
C faces outside of the crankcase.
B Inside of the crankcase
D Outside of the crankcase
• Apply THREAD LOCK SUPER to the bearing retainer screws.
& 99000-32030: THREAD LOCK SUPER “1303”
• Install the bearing retainers and tighten their screws.
To Next Page
Loading...
