FUEL SYSTEM 12-15
• Reassemble the hot start valve
E to the hot start cable end.
ACCELERATION PUMP TIMING
If turn the stop screw of the acceleration pump, adjust the accel-
eration pump timing after assemble the carburetor.
• Select a pin
B of the same diameter as the throttle valve
height
A and insert it under the throttle valve.
% Throttle valve height: 4.4 mm (0.173 in)
• Turn in the stop screw
C fully.
• Check play of the link lever
D.
• Turn the stop screw
C counterclockwise gradually until no
free play is available on the link lever
D.
CAUTION
Replace the gasket with a new one.
To Next Page
Loading...
