Suzuki RM-Z250 - Fuel Tank and Fuel Pump Removal

FRONT AND REAR BRAKES 16-11
• Install the springs and boots.
• Apply SUZUKI SILICONE GREASE to the caliper axles.
& 99000-25100: SUZUKI SILICONE GREASE
• Install the caliper bracket.
• Install the brake pads.
• Temporarily tighten the brake pad mounting pin.
• Tighten the brake pad mounting pin

1 to the specified torque.
# Brake pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
• Set the brake hose end between the hose stopper, then
tighten the brake hose union bolt

2 to the specified torque.
# Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the rear wheel. ($15-11)
• Refill brake fluid and bleed air from the brake system.
($16-3)
CAUTION
The seal washers should be replaced with new ones to
prevent fluid leakage.