17-24 FRONT FORK AND STEERING
• Tighten the handlebar holder set nuts to the specified torque.
& Handlebar holder set nut: 44 N·m (4.4 kgf-m, 32.0 lb-ft)
• Apply grease to the throttle cable and their hole.
( 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Align the matching mark
D on the handlebars with the throttle
holder matching surface.
• Tighten the screws securely.
• Align the matching mark
E on the handlebars with the master
cylinder matching surface.
• Tighten the upper bolt first temporarily to provide clearance
on the lower side and then tighten both the bolts to the speci-
fied torque.
& Master cylinder holder bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
To Next Page
Loading...
