097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 185
Appendix B Command Descriptions and Communications Interface
CLI Commands
Alias
Use this command to create a short form of a frequently used command.
Command Syntax:
To assign an alias name to a command (or any portion of a command):
alias <user-defined-alias>=<character-string>
To display all defined aliases and the commands to which they have been
assigned:
alias
Example 1:
To set the alias “abc” for the command “show ip status”
tc1000> alias ip=show ip status
Example 1a:
To use the alias “abc” to execute the command show ip status
tc1000> ip
Response 1a:
eth0: negotiated 100baseTx-FD flow-control, link ok
eth1: negotiated 100baseTx-FD flow-control, link ok
eth0 Link encap:Ethernet HWaddr 00:B0:AE:01:25:85
inet addr:192.168.5.62 Bcast:192.168.5.255 Mask:255.255.255.0
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:177125 errors:0 dropped:0 overruns:0 frame:0
TX packets:341 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:11003080 (10.4 Mb) TX bytes:40789 (39.8 Kb)
Interrupt:9 Base address:0xc000
eth1 Link encap:Ethernet HWaddr 00:B0:AE:01:25:86
inet addr:10.0.0.101 Bcast:10.0.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:176695 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:10976936 (10.4 Mb) TX bytes:0 (0.0 b)
Interrupt:9 Base address:0xf000 Memory:fbfaf000-fbfb0000
To Next Page
Loading...
Need help?
General
