202 TimeCreator 1000 User’s Guide 097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
CLI Commands
To provision the firewall to allow or block NTP traffic -
set firewall ntp {enable|disable}
To provision the firewall to allow or block SNMP traffic -
set firewall snmp {enable|disable}
To provision the firewall to allow or block RADIUS traffic -
set firewall radius {enable|disable}
To provision the firewall to allow or block TACACS+ traffic -
set firewall tacplus {enable|disable}
To provision the firewall to allow or block Syslog traffic -
set firewall syslog {enable|disable}
Example 1:
To enable the firewall to allow NTP traffic -
tc1000> set firewall ntp enable
Example 2
To disable the firewall to block RADIUS traffic -
tc1000> set firewall radius enable
Related: show firewall
Level : Power-User and Admin only
To Next Page
Loading...
Need help?
General
