Symmetricom TimeCreator 1000 User Manual

097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 203
Appendix B Command Descriptions and Communications Interface
CLI Commands
Generate Message
Use this command to generate all TimeCreator 1000 traps in one run, or to generate
a specific trap. This command essentially acts as a trap simulator.
Command Syntax:
 To generate all trap messages -
generate message
 To generate a specific trap message -
tc1000>generate message
“trapID,trapAID1,trapAID2,trapState,trapValue”
Example 1:
To generate all trap messages -
tc1000>generate message
Example 2a:
To generate the message for the trap “IMC-IOC 1 communication failed”, which has ID=2,
trapAID1=257 (corresponds to trapAID1=1 for IOC1 in
Table A-6) trap AID2=n/a (use 0),
trapState=2, and trapValue=n/a (use 0
) -
tc1000>generate message “2,257,0,2,0”
Example 2a:
To generate the message for the trap “IMC-IOC 1 communication restored”, which has ID=2,
trapAID1=257 (corresponds to trapAID1=1 for IOC1 in
Table A-6) trap AID2=n/a (use 0),
trapState=1, and trapValue=n/a (use 0
) -
tc1000>generate message “2,257,0,1,0”
Related: show log
Level : User, Power-User and Admin
Note: See Table A-6 for the the alarm trap bindings “trapID”,
“trapAID1”, “trapAID2”, “trapState” and “trapValue”.
See Table A-8 for the the event trap bindings.
If trapAID1 corresponds to the IOC module number,1 or 2, use the
value trapAID1=257 for IOC1 and trapAID1=258 for IOC2. Use the
number “0” for entries of “n/a”, such as for trapAID2 and trapValue.

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English