Symmetricom TimeCreator 1000 User Manual

206 TimeCreator 1000 User’s Guide 097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
CLI Commands
tc1000>set gps mode manual position n37:22:45.123
w121:55:36.123 17.5 mask 25
If GPS is already set to manual mode -
tc1000>set gps position n37:22:45.123 w121:55:36.123 17.5
mask 25
Example 3:
To manually provision the GPS elevation mask to a value of 18 degrees -
tc1000>set gps mode manual mask 18
If GPS is already set to manual mode -
tc1000>set gps mask <mask value>}
Remarks: The system must have the GPS mode of operation provisioned as
manual before you can successfully provision the position manually.
Latitude is in the format N|Sdd:mm:ss.sss, for example:
N37:22:45.123
S48:33:67.456
Longitude is in the format E|Wddd:mm:ss.sss, for example:
W121:55:36.123
E157:33:47.456
Height is in meters with one digit after the decimal point, for example: 17.5
Mask is in degrees, for example: 15
Note: Before changing GPS parameters, verify that the TOD source
has been set to GPS with the command
tc1000>show tod-source
If the the TOD source is not set to GPS, type the command
tc1000>set tod-source gps
Note: The GPS port state must also be enabled for positioning
changes to be implemented.
tc1000>set interface state gps enable

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English