097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 205
Appendix B Command Descriptions and Communications Interface
CLI Commands
Set GPS
Use this command to provision the GPS for mode of operation, position, and
positioning elevation mask. With this command, you can provision the GPS to use
either automatic or manual mode to determine the system’s position. You can
provision the GPS position if the system is provisioned for Manual mode of
operation. You can also provision the elevation mask to provide a method of filtering
satellites to be used by the system.
Command Syntax:
To provision GPS to manual or auto mode -
set gps mode [auto|manual]
To manually provision the GPS position -
set gps mode manual position <lat> <long> <height>
[mask <mask value>]
If GPS is already set to manual mode -
set gps position <lat> <long> <height> [mask <mask value>]
To manually provision the GPS elevation mask-
set gps mode manual mask <mask value>}
If GPS is already set to manual mode -
set gps mask <mask value>}
Example 1:
To provision GPS to auto mode -
tc1000>set gps mode auto
Example 2:
To provision the GPS reference for manual mode and specify the position as a
latitude of N37.22.45.123, longitude of W121.55.36.123, height of 17.5 meters, with
a mask of 25 degrees, perform the following steps -
Note: Latitude and Longitude are entered as pddd:mm:ss.sss, where
p is N or S for latitude and E or W for longitude, ddd is degrees, mm is
minutes, and ss.sss is seconds. For example: N59:20:3.458 or
W121:31:42.69. Height is in meters.
To Next Page
Loading...
Need help?
General
