Symmetricom TimeCreator 1000 User Manual

097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 225
Appendix B Command Descriptions and Communications Interface
CLI Commands
Set IP State
Use this command to enable or disable the specified Ethernet interface. You must
restart the interface after you configure it.
Command Syntax:
set ip-state {eth0|eth1} {enable|disable|restart}
Example 1:
To enable the ETH1 inteface -
tc1000>set ip-state eth1 enable
Example 2:
To restart the ETH1 inteface -
tc1000>set ip-state eth1 restart
Remarks: Restart disables the interface and then enables it.
Related:
show ip
Level : Power-User and Admin only

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English