Symmetricom TimeCreator 1000 User Manual

224 TimeCreator 1000 User’s Guide 097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
CLI Commands
Set IP-Mode
Use this command to set the DHCP mode for both Ethernet interfaces. You can set
up the interface to use either DHCP or a static IP.
Command Syntax:
set ip-mode {eth0|eth1} mode {dhcp|static}
Example:
To set ETH1 to static IP mode -
tc1000>set ip-mode eth1 mode static
Remarks: Use Set IP-State to restart the interface after configuring the system.
Related:
show ip, set ip, set ip-state
Level : Power-User and Admin only

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English