2-17
2
4st 25/30 2022
Functional Limit Action To Be Taken
-
Check if rotating parts, sliding parts and sealing parts cause
compression leakage.
-
Adjust to specified range
-
,1ѮPPLQ
Replace if less than specified limit
(;ѮPPLQ
IN: 0.05 mm (0.0020 in)
Replace if more than specified limit
EX: 0.03 mm (0.0012 in)
,1ѮPPLQ
Replace if more than specified limit
(;ѮPPLQ
IN: 0.070 mm (0.0028 in)
Replace if more than specified limit
EX: 0.100 mm (0.0039 in)
IN: 2.0 mm (0.0787 in)
Correct or replace if more than specified limit
EX: 2.0 mm (0.0787 in)
IN: 31.5 mm (1.2402 in)
Replace if less than specified limit
EX: 31.5 mm (1.2402 in)
ѮPPLQ Replace if more than specified limit
ѮPPLQ Replace if less than specified limit
0.060 mm (0.0024 in) Replace if more than specified limit
ѮPPLQ Replace if less than specified limit
0.15 mm (0.0059 in) Replace if more than specified limit
-
Clean to remove. Replace with a new one if the stains cannot be
fully removed even after cleaning.
0.10 mm (0.0039 in)
Replace if the gap is over the specified limit
Replace the oil ring at the same time when replacing the top or
second ring.
0.09 mm (0.0035 in)
0.15 mm (0.0059 in)
ѮPPLQ Replace if more than specified limit
ѮPPLQ Replace if less than the specified value
0.040 mm (0.0016 in) Replace if more than specified limit
0.50 mm (0.0197 in)
Replace if the gap is over the specified limit
Replace the oil ring at the same time when replacing the top or
second ring.
0.70 mm (0.0276 in)
0.90 mm (0.0354 in)
8SSHUVHFWLRQѮPPLQ
ѮPPLQ
ѮPPLQRUPRUHQRFRQWDFW
#3 - oil pump: 33.600 mm (1.3228 in)
Replace if more than specified limit
Distortion: 0.1 mm (0.0039 in)
or when the sealing performance may be affected.
Resurface by laying a #240 - 400 waterproof abrasive paper on the
surface plate. Use #600 for finish.
- Clean to remove
- Clean to remove
To Next Page
Loading...
Need help?
General
