Tormach PCNC 440 - Page 105

Chapter 7
105
UM10372_PCNC440_Manual_0221A
PROgRAMMiNg
To impose a dierent order (e.g. to turn coolant o before the spindle is stopped), code the
commands on separate blocks.
Order of Execution
Order Item
1 Comment (including message)
2 Set feed rate mode (G93, G94, G95)
3 Set feed rate (F)
4 Set spindle speed (S)
5 Special I/O (M62 to M68) – currently not supported
6 Change tool (T)
7 Spindle on/o (M03, M05)
8 Save State (M70, M73, restore state (M72), invalidate state (M71)
9 Coolant on/o (M07, M08, M09)
10 Enable/disable overrides (M48, M49, M50, M51, M52, M53)
11 Operator dened commands (M100 to M199)
12 Dwell (G04)
13 Set acve plane (G17, G18, G19)
14 Set length units (G20, G21)
15 Cuer radius compensaon on/o (G40, G41, G42)
16 Tool table oset on/o (G43, G49)
17 Fixture table select (G54 – G58 and G59 P~)
19 Set path control mode (G61, G61.1, G64)
19 Set distance mode (G90, G91)
20 Set canned cycle return level mode (G98, G99)
21 Home, change coordinate system data (G10) or set osets (G92, G94)
22 Perform moon (G00 to G03, G12, G13, G80 to G89 as modied by G53)
23 Stop (M00, M01, M02, M30, M60)