Tormach PCNC 440 - 6.9.3 Probe;ETS Setup Tab; 6.10 ADMIN Commands

Chapter 6
95
UM10372_PCNC440_Manual_0221A
PATHPilOT iNTERFACE
6.9.3 Probe/ETS Setup Tab
The Probe/ETS Setup tab is used to align and set the probe and ETS heights (see Figure 6.40). For
informaon on probe and ETS setup, refer to chapter 8, Accessories.
6.10 ADMIN Commands
Several ADMIN commands are provided for operator use. Below is a list of commands used in the
PathPilot interface:
ADMIN Command Description
ADMIN CONFIG Switch conguraon
ADMIN DATE Customize controller date and me
ADMIN DISPLAY Customize controller screen display
ADMIN KEYBOARD Customize controller keyboard layout
ADMIN NETWORK WIFI network setup
ADMIN OPENDOORMAXRPM
Set spindle speed RPM with spindle door open; for use with Full
Enclosure Door Switch Kit (PN 35550)
ADMIN SETTINGS BACKUP Save tool oset and xture informaon backup to store externally
ADMIN SETTINGS RESTORE
Restore tool oset and xture informaon backup from external
locaon
ADMIN TOUCHSCREEN
Calibrate touch screen; for use with 17" Touch Screen Kit (PN
35575)
Figure 6.40