Tormach PCNC 440 - Probe

Chapter 8
155
UM10372_PCNC440_Manual_0221A
ACCESSORiES
8.3.3 USB M-code I/O Interface Kit
This device allows the user to assign custom M-code commands to three opcally isolated inputs
and four relay contact outputs. This is useful for integrang a beacon light, auto part loader, or
pneumac vise via program command.
PN Description
32616 USB M-code I/O Interface Kit
8.3.4 Kress Spindle Kit
This electric-die grinder
serves as a companion
spindle to primary mill
spindle (see Figure 8.6).
Maximum speed of
29,000 RPM; used for
light milling/engraving.
The horizontal mounng
kit (see Figure 8.7) is
useful for light-end work
on long parts.
NOTE: Kress spindle is not
compable with ood/mist
coolant.
PN Spindle Type Coolant Compatible
31890 Kress Companion Spindle Kit (vercal) No
32444 Kress Companion Spindle Kit, Horizontal Adaptor —
8.3.5 Probe
Tormach’s Passive Probe (see Figure 8.8) is used to:
• Digize a surface
• Probe a Z surface
• Probe X or Y surface
PN Description Polarity
32309 Passive Probe w/10 mm TTS Mount Passive-Low
Figure 8.6
Figure 8.7