Tormach PCNC 440 - Probe Tab

Chapter 6
92
UM10372_PCNC440_Manual_0221A
PATHPilOT iNTERFACE
To Change the Layer or Shape Cut Order
To change the shape order, use the Up Arrow and Down Arrow buons above the shape selecon
tree view window. Shapes or layers higher in the tree view window are cut earlier than those below
it.
The order in which the shapes are cut matches the order of the enabled shapes in the tree view
window and the cyan path in the Preview window.
If a layer is selected, the whole layer is moved up or down. Shapes can’t be moved between layers.
To Adjust the Tree View Window
Use the Fold and Unfold buons to collapse and expand the layer and shape tree in the tree view
window.
6.8.8.2 Working in the Preview Window
The Preview window uses the following colors:
• Selected paths are cyan
• Disabled paths are gray
• The drawing path is white
• The cut path is magenta
• The tool path between cuts is a dark cyan sppled line
• The coordinates are idened as follows:
• The X-axis is red
• The Y-axis is green
• The Z-axis is blue
6.9 Probe Tab
The Probe tab contains automated funcons to nd X/Y/Z locaons, set work osets, probe pockets,
slots or bosses, as well as instrucons on probe and toolseer setup and calibraon. The Probe tab
contains a separate, smaller notebook that consists of three tabs:
• X/Y/Z Probe
• Rect/Circ
• Probe/ETS Setup