Tormach PCNC 440 - 6.6 Settings Tab; 6.6.1 Selecting the Tool Changer Type

Chapter 6
67
UM10372_PCNC440_Manual_0221A
PATHPilOT iNTERFACE
6.6 Settings Tab
The Sengs tab displays acve sengs of the PathPilot controller, allowing you to congure
PathPilot to suit your machine conguraon (see Figure 6.16).
The window on the le side of the Sengs tab displays a list of available G-code modalies. Acve
G-codes are highlighted in yellow (see Figure 6.16).
6.6.1 Selecting the Tool Changer Type
Select the tool changer type that matches mill conguraon. The mill behavior when it encounters
an M6 command is dierent depending on which tool changing opon is selected on this screen.
Figure 6.15