Tormach PCNC 440 - Part Setup;Workholding

Chapter 4
42
UM10372_PCNC440_Manual_0221A
OPERATiON
4.6 Part Setup/Workholding
Work must be secured to the table prior to machining. Each PCNC 440 has three 10 mm T-slots that
run parallel to the X-axis. The slots are precision ground to +0.008”.
A 4” vise is recommended. Tormach oers the following vise:
PN Description
35285 4” CNC Vise
For more informaon on proper setup and use of the 4” CNC Vise, refer to documentaon that ships
with product.
A number of other ways can be employed for workholding. These include toe clamps, xture plates,
chucks, and vacuum tables.