Tormach PCNC 440 - Page 5

Chapter 1
5
UM10372_PCNC440_Manual_0221A
PREFACE
Electrical Cabinet: Never operate the mill with the electrical cabinet open. Never allow a coolant
pump to operate with the electrical cabinet open. Do not allow the coolant system to ow coolant
directly at the electrical cabinet or the operator box. Neither the electrical cabinet nor the operator
box controls are hermecally sealed against liquids.
Electrical Service: Certain service and troubleshoong operaons require access to the electrical
cabinet while power is on. Only qualied electrical technicians should perform such operaons.
Retained Electrical Power: Electronic devices within the electrical cabinet may retain dangerous
electrical voltage aer the power is o.
Support
Tormach provides no-cost technical support to our customers through mulple channels. The
quickest way to get the answers you need is normally in this order:
• Refer to this operator manual rst
• Reference related documents at: hp://www.tormach.com/documents.html
• Email: info@tormach.com
• Phone: 608-849-8381 x2001, Monday through Friday 8 a.m. to 5 p.m. (central standard me)
• Fax: 209-885-4534
Scope and Intellectual Property
This document is intended to provide sucient informaon to allow you to install, setup, and use
your Tormach PCNC 440 mill. It assumes that you have appropriate experience and/or access to
training for any computer-aided design/manufacture soware to use with the machine.
Tormach Inc. is dedicated to connual improvement of its products, so suggesons for enhancements,
correcons, and claricaons are welcome.
The right to make copies of this manual is granted solely for the purpose of training courses related
to, evaluaon of and/or use of the PCNC 440. It is not permied, under this right, for third pares
to charge for copies beyond the cost of prinng.
Every eort has been made to make this manual as complete and as accurate as possible but no
warranty or tness is claimed or implied. All informaon provided is on an as is basis. The authors,
publisher, and Tormach Inc. shall not have any liability for, or responsibility to, any person or enty
for any reason for any loss or damage arising from the informaon contained in this manual.
Tormach, PCNC 440 Personal CNC, Tormach Tooling System (TTS), and PathPilot are trademarks
or registered trademarks of Tormach Inc. If other trademarks are used in this manual, but not
acknowledged, please nofy Tormach Inc. so this can be remedied in subsequent edions.
Tormach milling machines and accessories are covered by one or more of the following U.S. Patents:
7,386,362, D606,568, D612,406, D621,859 and Patent(s) Pending.