C69618
C69619
C92869
SST
C69620
–MANUAL TRANSMISSION/TRANSAXLE INPUT SHAFT ASSY (E351)
41–55
2185Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
11. REMOVE SYNCHRONIZER RING NO.3
(a) Remove the synchronizer ring No.3 from the 3rd gear.
12. REMOVE TRANSMISSION HUB SLEEVE NO.2
(a) Remove the transmission hub sleeve No.2, 3 synchro-
mesh shifting keys and 3 synchromesh shifting key
springs from the transmission clutch hub No.2.
NOTICE:
Using a waste to prevent the shifting key and shifting key
spring from being scattered.
13. REMOVE INPUT SHAFT FRONT BEARING
(a) Using SST and a press, remove the input shaft bearing
front (inner race) from the input shaft.
SST 09950–00020
NOTICE:
Do not tighten SST excessively.
14. INSPECT INPUT SHAFT
(a) Using V–block and dial indicator, measure the shaft run
out.
Maximum run out: 0.03 mm (0.0012 in.)
If the run out exceeds the maximum, replace the input shaft.
To Next Page
Loading...
