Toyota 2002 Camry - Page 724

C92870
ABC
C69622
C69622
C69623
41–56
–MANUAL TRANSMISSION/TRANSAXLE INPUT SHAFT ASSY (E351)
2186Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(b) Using a micrometer, measure the outer diameter of the in-
put shaft journal surface.
Outer diameter: mm (in.)
Standard outer diameter Minimum outer diameter
A
35.984 – 36.000
(1.4167 – 1.4173)
35.984
(1.4167)
B
35.984 – 36.000
(1.4167 – 1.4173)
35.984
(1.4167)
C
27.957 – 27.972
(1.1007 – 1.1013)
27.957
(1.1007)
If the outer diameter is less than the minimum, replace the input
shaft.
15. INSPECT 4TH GEAR
(a) Using a cylinder gauge, measure the inside diameter of
the 4th gear.
Inside diameter: mm (in.)
Standard inside diameter Maximum inside diameter
42.009 – 42.025
(1.6539 – 1.6545)
42.025
(1.6545)
16. INSPECT 3RD GEAR
(a) Using a cylinder gauge, measure the inside diameter of
the 3rd gear.
Inside diameter: mm (in.)
Standard inside diameter Maximum inside diameter
43.009 – 43.025
(1.6933 – 1.6939)
43.025
(1.6939)
17. INSPECT 2ND SYNCHRONIZER OUTER RING
(a) Coat the 4th gear cone with gear oil. Turn the synchroniz-
er ring No.3 in one direction while pushing it to the 4th
gear cone. Check that the ring locks.