C69624
C69625
C69626
C67843
–MANUAL TRANSMISSION/TRANSAXLE INPUT SHAFT ASSY (E351)
41–57
2187Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(b) Using a feeler gauge, measure the clearance between
the synchronizer outer ring back and 4th gear spline end.
Standard clearance:
0.75 – 1.65 mm (0.0295 – 0.0650 in.)
If the standard clearance is out of specification, replace the syn-
chronizer ring.
18. INSPECT SYNCHRONIZER RING NO.3
(a) Coat the 3rd gear cone with gear oil. Turn the synchroniz-
er outer ring in one direction while pushing it to the 3rd
gear cone. Check that the ring locks.
(b) Using a feeler gauge, measure the clearance between
the synchronizer ring No.3 back and 3rd gear spline end.
Standard clearance:
0.65 – 1.75 mm (0.0256 – 0.0689 in.)
If the standard clearance is out of specification, replace the syn-
chronizer ring No.3.
19. INSPECT TRANSMISSION HUB SLEEVE NO.2
(a) Inspect the sliding condition between transmission hub
sleeve No.2 and transmission clutch hub No.2.
(b) Inspect tip of spline gear on the transmission hub sleeve
No.2 for wear.
To Next Page
Loading...
