Toyota 2002 Camry - Page 727

C69629
C69630
C92872
SST
C69632
–MANUAL TRANSMISSION/TRANSAXLE INPUT SHAFT ASSY (E351)
41–59
2189Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
23. INSTALL 3RD GEAR
(a) Coat the 3rd gear with gear oil, install it to the input shaft.
24. INSTALL SYNCHRONIZER RING NO.3
(a) Coat the synchronizer ring No.3 with gear oil, install it to
the 3rd gear.
25. INSTALL TRANSMISSION CLUTCH HUB NO.2
(a) Using SST and a press, install the transmission clutch
hub No.2 to the input shaft.
SST 09316–60011 (09316–00041)
NOTICE:
 Align the claw of clutch hub No.2 with notch of syn-
chronizer ring No.3 and install them.
 Make sure that the 3rd gear should rotate.
(b) Select a snap ring so that clearance between the trans-
mission clutch hub No.2 and the clutch hub No.2 shaft
snap ring will be the standard clearance. Using a brass
bar and a hammer, install the snap ring.
Standard clearance: 0.1 mm or less (0.0039 or less)
Snap ring thickness
Part No. Thickness: mm (in.) Mark
90520–34003
2.30 – 2.35
(0.0906 – 0.0925)
H
90520–34004
2.35 – 2.40
(0.0925 – 0.0945)
J
90520–34005
2.40 – 2.45
(0.0945 – 0.0965)
K
90520–34006
2.45 – 2.50
(0.0965 – 0.0984)
L
90520–34007
2.50 – 2.55
(0.0984 – 0.1004)
M
90520–34008
2.55 – 2.60
(0.1004 – 0.1024)
N
90520–34009
2.60 – 2.65
(0.1024 –0.1043)
P