Toyota 2002 Camry - Page 729

C69635
C69549
–MANUAL TRANSMISSION/TRANSAXLE INPUT SHAFT ASSY (E351)
41–61
2191Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(b) Select a snap ring so that the clearance between the In-
put shaft radial ball rear bearing and the input shaft rear
bearing snap ring will be the standard clearance. Using
a brass bar and a hammer, install the snap ring.
Standard clearance: 0.1 mm or less
Snap ring
Part No. thickness: mm (in.) Mark
90520–30008
2.35 – 2.40
(0.0925 – 0.0945)
1
90520–30009
2.40 – 2.45
(0.0945 – 0.0965)
2
90520–30010
2.45 – 2.50
(0.0965 – 0.0984)
3
90520–30011
2.50 – 2.55
(0.0984 – 0.1004)
4
90520–30012
2.55 – 2.60
(0.1004 – 0.1024)
5
90520–30013
2.60 – 2.65
(0.1024 – 0.1043)
6
90520–30021
2.65 – 2.70
(0.1043 – 0.1063)
7
90520–30022
2.70 – 2.75
(0.1063 – 0.1083)
8
31. INSPECT 3RD GEAR RADIAL CLEARANCE
(a) Using a dial indicator, measure the 3rd gear radial clear-
ance.
Standard clearance: mm (in.)
Bearing Standard clearance
KOYO made
0.009 – 0.053
(0.0004 – 0.0021)
NSK made
0.009 – 0.051
(0.0004 – 0.0020)
If the clearance exceeds the maximum, replace the 3rd gear
needle roller bearing.