Toyota 2002 Camry - Page 847

F41515
SST
F41516
SST
F41517
SST
SST
Rack Guide
Spring Cap
F41518
SST
Fulcrum Length
Rack Guide Spring
Cap Nut
SST
51–42
–POWER STEERING RACK & PINION POWER STEERING GEAR ASSY
2309Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(c) Using SST, loosen the rack guide spring cap.
SST 09631–10021
(d) Using SST, turn the control valve to the right and left 1 or
2 times.
SST 09616–00011
(e) Using SST, loosen the rack guide spring cap until the
compression spring is not functioning.
SST 09631–10021
(f) Using SST and a torque wrench, tighten the rack guide
spring cap until the preload is within specification.
SST 09616–00011, 09631–10021
Preload (turning):
1.2 – 1.5 N⋅m (12.2 – 15.3 kgf⋅cm, 10.6 – 13.3 in.⋅lbf)
(g) Apply sealant to 2 or 3 threads of the rack guide spring
cap nut.
Sealant:
Part No. 08833–00080, THREE BOND 1344, LOCTITE
242 or equivalent
(h) Temporarily install the rack guide spring cap nut.
(i) Using SST, hold the rack guide spring cap and using
another SST, torque the rack guide spring cap nut.
SST 09616–00011, 09922–10010
Torque: 48 N⋅m (489 kgf⋅cm, 35 ft⋅lbf)
NOTICE:
Use SST 09922–10010 in the direction shown in the illustra-
tion.
HINT:
Use a torque wrench with a fulcrum length of 345 mm (13.58
in.).
(j) Precheck the total preload.
Preload (turning):
1.2 – 1.5 N⋅m (12.2 – 15.3 kgf⋅cm, 10.6 – 13.3 in.⋅lbf)
(k) Remove the RH and LH steering rack ends sub–assy.