F40555
MP Grease
F40538
Vinyl Tape
F41576
SST
SST
Fulcrum
Length
Fulcrum Length
C35928
–POWER STEERING RACK & PINION POWER STEERING GEAR ASSY
51–43
2310Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(l) Apply MP grease into the control valve, as shown in the
illustration.
(m) Wind vinyl tape around the serration part of the control
valve.
(n) Install the dust cover to the control valve housing.
49. INSTALL STEERING RACK END SUB–ASSY
(a) Install a new 2 claw washers, and temporarily install the
2 steering rack ends sub–assy.
HINT:
Align the claws of the claw washer with the power steering rack
grooves.
(b) Using 2 SSTs, install the 2 steering rack ends sub–assy.
SST 09922–10010
Torque: 58.5 N⋅m (597 kgf⋅cm, 43 ft⋅lbf)
NOTICE:
Use SST 09922–10010 in the direction shown in the illustra-
tion.
HINT:
Using SST, hold the power steering rack and install the
steering rack end sub–assy.
Use a torque wrench with a fulcrum length of 345 mm
(13.58 in.).
(c) Using a brass bar and a hammer, stake the claw washer.
NOTICE:
Avoid any impact to the power steering rack.
To Next Page
Loading...
