Toyota 2002 Camry - Page 849

ZX9390
F41951
F40556
SST
51–44
–POWER STEERING RACK & PINION POWER STEERING GEAR ASSY
2311Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
50. INSPECT STEERING RACK END SUB–ASSY
(a) Ensure that the steering rack end sub–assy hole is not
clogged with grease.
HINT:
If the hole is clogged, the pressure inside the boot will change
after it is assembled and steering wheel is turned.
51. INSTALL STEERING RACK BOOT NO.2
(a) Install the steering rack boot No.2.
52. INSTALL STEERING RACK BOOT NO.1
HINT:
Remove the steering rack boot No.1 by the same procedures with steering rack boot No.2.
53. INSTALL STEERING RACK BOOT NO.2 CLAMP
(a) Using SST, tighten the steering rack boot No.2 clamp, as
shown in the illustration.
SST 09521–24010
Clearance: 3.0 mm (0.118 in.) or less
NOTICE:
Be careful not to damage the boot No.2.
54. INSTALL STEERING RACK BOOT NO.1 CLAMP
SST 09521–24010
NOTICE:
Be careful not to damage the boot No.1.
HINT:
Install the steering rack boot No.1 clamp by the same proce-
dures with steering rack boot No.2 clamp.
55. INSTALL STEERING RACK BOOT CLIP
(a) Using pliers, install the 2 steering rack boot clips.
56. INSTALL TIE ROD ASSY LH
(a) Screw the lock nut and tie rod assy LH onto the steering rack end sub–assy until the matchmarks are
aligned.
HINT:
After adjusting toe–in, torque the lock nut.
57. INSTALL TIE ROD ASSY RH
HINT:
Install the RH side by the same procedures with LH side.