Toyota 2002 Camry - Page 850

F41519
Fulcrum
Length
SST
F41613
Fulcrum
Length
SST
F41496
–POWER STEERING RACK & PINION POWER STEERING GEAR ASSY
51–45
2312Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
58. INSTALL STEERING LEFT TURN PRESSURE TUBE
(a) Coat 2 new O–rings with power steering fluid and install
them to the left turn pressure tube.
(b) Using SST, install the left turn pressure tube to the rack
& pinion power steering gear assy.
SST 09023–38200
Torque: 11.5 N⋅m (117 kgf⋅cm, 8 ft⋅lbf)
HINT:
 Use a torque wrench with a fulcrum length of 345 mm
(13.58 in.).
 This torque value is effective in the case that SST is paral-
lel to a torque wrench.
59. INSTALL STEERING RIGHT TURN PRESSURE TUBE
(a) Coat 2 new O–rings with power steering fluid and install
them to the right turn pressure tube.
(b) Using SST, install the right turn pressure tube to the rack
& pinion power steering gear assy.
SST 09023–38200
Torque: 11.5 N⋅m (117 kgf⋅cm, 8 ft⋅lbf)
HINT:
 Use a torque wrench with a fulcrum length of 345 mm
(13.58 in.).
 This torque value is effective in the case that SST is paral-
lel to a torque wrench.
60. INSTALL POWER STEERING RACK HOUSING HEAT INSULATOR(1MZ–FE ENGINE TYPE)
(a) Install power steering rack housing heat insulator.
HINT:
Install nut when installing the return tube clamp.
61. INSTALL RACK & PINION POWER STEERING GEAR
ASSY
(a) Install the rack & pinion power steering gear assy with the
2 bolts and nuts.
Torque: 70 N⋅m (714 kgf⋅cm, 52 ft⋅lbf)