More Information
‣
Connecting Sensor and Device Cables (page 218)
11.3 Installing SR50A
• 5-mm Allen key
• 7-mm wrench
In AWS310, SR50A is used as a snow depth sensor.
Mount a sensor support arm to a suitable place depending on the intended use, and mount
the sensor on the sensor support arm.
For the most reliable measurements:
• Mount the sensor at least 50 cm (20 in) above the highest expected target level, but
not too far away from it. For example, if the snow level is not likely to exceed 1.25 m
(4 ft 1 in), mount the sensor to approximately 2 m (6 ft 7 in).
Chapter 11 – Sensor Installation to Sensor Support Arm
119
To Next Page
Loading...
Need help?
General
