EasyManuals Logo

Vaisala AWS310 User Manual

Vaisala AWS310
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #211 background imageLoading...
Page #211 background image
5. Loosen the central attachment bolt in the bucket overlay (the bolt is secured with 2 hex
nuts).
6. Remove the bucket overlay.
7. Unscrew the 4 cross-head bolts on the cover of the electronics unit approximately
3 mm (0.12 in), raise the cover slightly and pull it o forward.
If the foam rubber seal for the cover is stuck to the surface below, carefully remove the
cover with a slothead screwdriver.
8. Place the base plate on the pedestal, so that the sensor cable runs through the opening
in the base plate.
9. Without fully tightening the 6 hex bolts, screw them into the base plate
flange with an
open-ended, 123‑mm (4.84‑in) wrench (supplied).
10. Connect the sensor cable between the terminal under the base plate and the weather
station.
More Information
‣
Connecting Sensor and Device Cables (page 218)
Chapter 16 – Precipitation Sensor Installation
209

Table of Contents

Other manuals for Vaisala AWS310

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vaisala AWS310 and is the answer not in the manual?

Vaisala AWS310 Specifications

General IconGeneral
BrandVaisala
ModelAWS310
CategoryWeather Station
LanguageEnglish

Related product manuals