Restriction
System
Option
Description
Call ARC Line
1
ARC message in line 1 of display (16 chars).
Call ARC Line
2
ARC message in line 2 of display (16 chars).
Show Cameras If enabled, offline cameras will be displayed on the keypad in Unset mode.
Log Keypad
Access
Enable this option to log users' keypad access (successful and failed log-in
attempts).
Idle State
Language
Select the language displayed in idle state.
l System Language: Language in which menus and texts on the keypads,
the web interface and the event log will be displayed.
l Last Used: Last used language is displayed in idle state.
Use Simplified
Menu
Enable this option to use simplified set/unset menus on the 'Comfort' and
'Compact' Keypads (for one area configuration only).
PIN
PIN Digits Enter the number of digits for user PINs (max. 8 digits). Increasing the number
of digits will add the relevant number of zeros to the front of an existing PIN, for
example, an existing user PIN of 2134 (4 digits) will change to 00002134 if the
PIN digits is set to 8. If you decrease the number of PIN digits, existing PINs
will have their leading digits removed, for example, an existing user PIN of
00002134 (8 digits) will change to 02134 if the PIN digits is set to 5.
Note: This option cannot be changed if an SPC Manager PIN digit mode is set.
See SPC Manager on page336.
Note: To comply with INCERT approvals, the user’s PIN code must contain
more than 4 digits.
PACE and PIN If enabled, both PACE and PIN are required.
User Duress Select one of the following Duress options to activate this function on the
system.
l PIN +1(system reserves the PIN before and after the user PIN for duress.
l PIN + 2 (system reserves two PINs before and after the user PIN for
duress.
Duress must be enabled for individual users. See section on Adding/Editing a
User.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 258 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
