17.10.3.3 Identification
1. Select Configuration > System > Identification.
The following page will be displayed.
2. Configure the fields as described in the table below.
Installation
ID
Enter a unique number for each installation This number identifies the
installation (1–999999).
Installation
Name
Enter the name of the installation. An installation name must be entered before
the installation is saved on the system. The installation can be viewed from
the keypad.
Installation
Date
Select the date from the dropdown menu that the installation was completed.
Installer
Name
Enter the name of the person who installed the system (for support purposes).
Installer
Phone
Enter the contact phone number of the person who installed the system (for
support purposes).
Display
Installer
Tick this box to display the installation details on the keypad connected to the
panel when in the idle condition.
Engineer
Lock
Tick this box to require use of the engineer lock PIN to factory default the
panel.
Engineer
Lock PIN
Enter value for lock PIN (4 digits).
17.10.3.4 Standards
All alarm systems must comply with defined security standards. Each standard has specific
security requirements that apply to the market/country in which the alarm system is installed.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 266 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
