Wacker Neuson WL34 - Checking the V-Belt Tension;Tensioning the V-Belt; Note on Toothed Belts

SHB WL34 * 2.0 1-49
Maintenance 1
Maintenance
Checking the V-belt tension/tensioning the V-belt
Preparations
1. Park the machine on firm, level and dry ground.
2. Apply the parking brake.
3. Fully retract the loader unit and lower it to the ground.
4. Stop the engine.
5. Wait one minute.
6. Open the engine cover.
Checking V-belt tension
Press with your thumb to check whether the V-belt can be deflected
between the pulleys by no more than about 10 mm (0.4 in).
Tensioning the V-belt
1. Loosen fastening bolts 2 of the alternator and set screw 1.
2. Apply pressure to the alternator with a suitable tool until reaching the
correct V-belt tension.
3. Hold the alternator in this position and tighten bolts 1 and 2.
Note on toothed belts
Information
Tooth belts may only be replaced by authorized Perkins/Deutz distribution
partners.
Fig. 56
Fig. 57
About 10 mm (0.4 in)
Fig. 58
1
2