1-10 SHB WL34 * 2.0
1 Maintenance
Maintenance overview
Inspection intervals
The maintenance and inspection personnel must have specialized
knowledge about the maintenance and inspection work on the machine.
► Observe the Operator’s Manual of the engine.
The maintenance specified in the inspection schedule must be performed
according to whichever interval is reached first, in other words, depending
on whether the operating hours are reached or the time interval specified
in the schedule is reached.
Clean the air filter, replace it if necessary
Adjust valve clearance (see the engine manufacturer’s manual)
Replace the hydraulic oil
Replace the hydraulic oil return filter
Replace the hydraulic oil pressure filter
Replace the oil in the transfer gearbox
Replace the oil in the axles
Perform grease lubrication according to the lubrication plan
Lubricate the cardan shaft
Lubricate with oil: all levers, Bowden cables and hinges
Check all oil/fluid levels
The following inspection intervals apply after this inspection:
Work to be performed at 500 operating hours
To Next Page
Loading...
