SHB WL34 * 2.0 1-77
Maintenance 1
Exhaust gas treatment
Manual regeneration
If automatic regeneration was interrupted manually, it starts again after
restarting the engine as soon as the engine reaches its operating
temperature.
However, regeneration can also be started manually as soon as the
machine is no longer in the direct vicinity of easily flammable material.
This is appropriate if it helps to avoid interrupting automatic regeneration
repeatedly, for example, if the machine is in regular operation in the direct
vicinity of easily flammable material.
Prerequisites for manual regeneration:
• The engine must be at its operating temperature.
• Control lamp 27 must illuminate.
Activate regeneration manually:
1. Drive the machine into a safe area with no easily flammable material.
2. Press and hold rocker switch 49 in position II for about 15–20 seconds
until control lamp 27 illuminates.
➥ The control lamp illuminates during the regeneration 29.
The machine can be operated without any restriction during manual
regeneration as long as there is no easily flammable material in the direct
vicinity of the machine.
For regeneration during idling:
• Apply the parking brake.
• Fully retract the loader unit and lower it to the ground.
• Shut off all electric consumers on the vehicle, e.g. rotating beacon,
lighting, radio, etc.
Regeneration takes about 30 minutes. This means that if regeneration is
started, the engine must run until regeneration is over, even if work with
the machine is finished before.
The control lamp goes out once regeneration is over and the exhaust
system has cooled down 29.
To Next Page
Loading...
