SHB WL34 * 2.0 1-59
Maintenance 1
Maintenance
Starting aid and jump-starting
Injury hazard due to malfunctioning batteries
Batteries give off explosive gases that can cause deflagrations if ignited.
► Do not smoke, avoid fire and open flames.
► Do not place any tools on the battery.
Short circuit when jump-starting the machine.
► Ensure that the vehicle giving a jump start and the machine do not
touch.
► Do not jump-start the machine if the battery is malfunctioning or frozen.
► Do not connect two batteries in series.
► Use only batteries with the same voltage for jump-starting.
► Use only tested battery jumper cables with insulated terminal clamps
and a sufficient cable cross-section.
► Route the battery jumper cables so that they cannot catch on rotating
engine parts.
► After jump-starting the machine, fit the cover of the positive terminal of
the machine back on again.
Before jump-starting, check whether the battery of the machine is still
functional:
1. Set all control levers and switches to the zero position.
2. Turn the starting key to position I.
➥ The indicator lights must illuminate.
3. The indicator lights do not illuminate.
- Malfunctioning battery.
➥ Do not jump-start the machine in this case.
➥ Install a functional battery.
Preparations
1. Set all control levers and switches to the zero position.
2. Turn the starting key to position 0.
➥ The electrical system is de-energized.
3. Drive the vehicle giving a jump start (charged battery) up to the
machine (battery to be charged) so that the batteries can be connected
by means of the battery jumper cables, but without the vehicles
touching.
4. Set all control levers and switches to the zero position on the machine
giving a jump start.
To Next Page
Loading...
