Wacker Neuson WL34 - Deutz Engine

1-38 SHB WL34 * 2.0
1 Maintenance
Maintenance
Deutz engine
1. Add fuel to the fuel tank.
2. Open the engine cover.
3. Place a container under the fuel filter.
4. Loosen bleed screw E (WS 13).
5. Actuate the manual feed pump pos. P until fuel comes out of bleed
screw E without any bubbles.
➥ The fuel filter is filled.
6. Tighten the bleed screw E (WS 13).
7. Pump with the manual feed pump pos. F until you feel a resistance.
8. Then pump a further 3 to 4 times.
➥ The engine is then ready to be started.
After starting the engine, let it run 2 to 3 minutes at idling speed to
complete the bleeding procedure.
Environment
Diesel fuel is harmful to the environment.
► Collect escaping diesel fuel and dispose of it in an environmentally
friendly manner.
Fig. 45
P
E
F