SHB WL34 * 2.0 1-9
Maintenance 1
Maintenance overview
Inspection after 500 operating hours
The maintenance and inspection personnel must have specialized
knowledge about the maintenance and inspection work on the machine.
► Observe the Operator’s Manual of the engine.
This inspection is performed once after the first 500 operating hours. If the
machine does not reach 500 operating hours during its first year of
operation, perform this inspection once 12 months after putting the
machine into operation.
Work to be performed at 500 operating hours
Check the gearbox, engine and hydraulic system for leaks
Check the engine and hydraulic oil radiator for dirt
Check the coolant level and antifreeze
Check the tension and condition of the V-belt
Check the routing of the hoses and pipes
Check the piston rods of the hydraulic cylinders
Check the air filter hose
Examine the intake muffler for damage or exceptional wear
Check the routing of Bowden cables and electric cables
Retighten all bolts; pay particular attention to the engine mountings, axle mountings and cardan shaft
Check the rubber buffers on the engine mountings
Check the battery acid level
Check the instruments, indicator lights and acoustic warning devices
Check the electrical system
Check the brake/inching pedal and parking brake, adjust if necessary
Check the steering system
Check the light system (if equipped)
Check the exhaust system
Check the pivot pins and joint bushes
Check the center pivot bolts and bearings
Check the idling speed
Check the engine cover and door locking mechanisms for correct function, adjust them if necessary
Check the tire condition and tire pressure
Replace the engine oil and engine oil filter
Replace the fuel filter, clean the fuel prefilter
Clean the fuel feed pump (Deutz engines only)
To Next Page
Loading...
