E-34 SHB WL34 * 2.0
E Introduction
Safety instructions
- Radiator
- Variable displacement pump and motor
- Hydraulic pump, cylinders, lines, hoses
- Steering orbitrol
- Valves
- Any part of the axles
-Pins
- Bearings
- Exhaust system.
• Reconnect the battery after welding (see Operator’s Manual,
“Removing the battery”).
Components can be damaged by heat or sparks.
► Cover components near the weld with dedicated protection mats.
► Keep components at a safe distance from the weld with appropriate
means.
► Ensure that the rear side of the weld is free from components which
can be damaged. If necessary, remove them or keep them at a safe
distance with appropriate means.
To Next Page
Loading...
