B-8 SHB WL34 * 2.0
B Operation
Overview of control elements
Warning light Engine oil pressure (red)
Illuminates when the starter is turned on and goes out as soon as the
engine runs.
Illuminates if the engine oil pressure is too low.
In this case:
1. Stop the vehicle.
2. Stop the engine and check the oil level – see "Engine lubrication
system" on page 1-39.
Alternator charge function warning light (red)
Illuminates when the starter is turned on and goes out as soon as the
engine runs.
Indicates with the engine running:
➥ Malfunctioning V-belt or malfunction in charging circuit of the
alternator. The battery is no longer charged – see "V-belt/toothed
belt" on page 1-48.
Preheating indicator light (yellow)
Illuminates when the key in the starter is in position 1.
High beam indicator light (blue)
Illuminates if high beam is switched on, or during headlight flashing.
Diesel particulate control lamps
Technical damage to the diesel particulate filter.
► Perform a complete ongoing regeneration of the diesel particulate filter
before the engine is shut off.
Indicator light “Diesel particulate filter regeneration required”
(yellow)
This indicator light provides general information on the soot load. It goes
out if the soot load is normal.
➥ If the indicator light illuminates, regenerating the diesel particulate
filter is necessary.
➥ Regeneration can be started manually.
Indicator light “Suppress diesel particulate filter regeneration”
(yellow)
This indicator light shows that regeneration has been suppressed.
➥ Regeneration can be started manually.
Indicator light “High exhaust-gas temperature” (yellow)
Illuminates during active regeneration. This indicator light shows that
increased exhaust-gas temperatures are possible.
To Next Page
Loading...
