WAREMA climatronic - Option 2: Manual Entry of Serial Numbers

890370_0•en•01.06.2009
We reserve the right to carry out improvements
54
WAREMA climatronic
®
Installation Instructions
 Press the function wheel; [ Wait for program key...] appears on the left.
 Now press the PROG button on the device to be identified.
 Its serial number then appears in the menu.
 Press the [OK] button.
 The menu can only be left with the [Next] button after all created sensors
have been identified.
This takes you directly to the next menu: [Select actuators].
Option 2: manual entry of
serial numbers
 Turn the function wheel until the line of the serial number is shown highlight-
ed in colour.
 Press the function wheel.
 The 8-digit serial number [OOOOOOOO] is shown enlarged:
NOTE The serial numbers of the sensors can be found in duplicate on a label in-
side the devices.
Enter the serial number as follows:
 Press the function wheel until the desired position is displayed. Alternatively,
you can also select the positions with the [<=] and [=>] buttons.
 Set the correct number by turning the function wheel.
Enter the remaining numbers in the same manner.
 Close by pressing the [OK] button.
NOTE Pull off a label and affix it to the table in Chapter 4.3.1 on page 23 for a better
overview.
NOTE Select the next sensor with the function wheel and identify as described
above.
NOTE The menu can only be left with the [Next] button after all created sen-
sors have been identified. This will take you directly to the next menu:
[Select actuators].
Assistant