WAREMA climatronic - Delay WIND; Delay WIND OFF; Direction-Dependent Wind Evaluation

890370_0•en•01.06.2009
We reserve the right to carry out improvements
92
WAREMA climatronic
®
Installation Instructions
Delay WIND
To prevent the sun shading product from raising at each brief blast of the
wind, a delay time can be assigned to the wind alarm for each channel.
When the limit values are reached or exceeded for the duration of this delay
time, a move command is triggered and the sun shading product is moved
to the set position and slat angle. The setting range is 0 to 99seconds.
Change the limit value as follows:
 Move to the [Delay WIND] line with the function wheel; press the function
wheel.
 Increase or reduce the delay by turning the function wheel. The [Standard]
button sets the value to the default value
 Press the function wheel to accept the value and to finish the input.
Delay WIND OFF
The wind alarm remains active for a certain time for reasons of safety and
comfort. This quiets the movement of the sun shading product because the
sun shading product is not moved for the duration of the off delay; it remains
in the "Wind" position.
After the off delay time has elapsed, the sun shading product can be moved
again using the comfort functions or manual operation. The setting range is 0
to 99 minutes.
Change "Delay WIND OFF" as follows:
 Move to the [Delay WIND OFF] line with the function wheel; press the func-
tion wheel.
 Increase or reduce the delay by turning the function wheel. The [Standard]
button sets the value to the default value.
 Press the function wheel to accept the value and to finish the input.
Direction-dependent wind
evaluation
If you scroll farther down with the function wheel (), you can select whether
the wind force should be evaluated in terms of its direction.
Channels