1.5 Intended Use
The APS is a hybrid inverter that converts the direct current from a DC source into
alternating current and feeds it into the grid and vice versa. The product may be used
solely in photovoltaic systems, energy storage systems and as STATIC VAR
COMPENSTATION (STATCOM).
Connection to the medium-voltage grid is provided with the aid of a distribution
transformer.
The product is constructed for outdoor use. It fulfils the IP65 degree of protection.
The product is not suitable for operation in areas with the risk of explosion and must be
kept away from flammable or combustible materials.
It is prohibited to open the product when it is raining or the humidity is greater than
95%.
For all work appropriate tools must be used.
Only operate the product with the maximum permissible connected loads stated in the
Section Technical Data.
The operating conditions given in the Section Technical Data must be fulfilled at all
times.
Always ensure that existing wiring is in good condition and that wire is not undersized.
Never operate the product with damaged or substandard wiring.
The manufacturer must not be liable for any damages resulting from unauthorized
persons conducting work on the product.
Never operate the product with open doors.
Never operate the product with any technical defects.
Never operate the product if it has been damaged in any way.
Never open the doors within the discharge time.
To reduce risk of fire hazard, do not cover or obstruct any ventilation openings.
Fill the cooling system with the prescribed amount of cooling fluid. An empty cooling
system can lead to the corrosion of the APS tubes and ball valves.
Improper use of the product may pose a substantial danger to all persons involved.
The type plate, product safety signs and labels must remain permanently attached to
the product.
Only the spare parts that are listed in this document may be used. The use of other
spare parts must be construed as an alteration.
Without approval of the grid operator do not switch off or adjust settings which have
influence on the grid management service.
All changes and/or modifications to the equipment, its structure or its software are
prohibited and will result in loss of warranty.
Intended use includes reading the original operating instructions and complying with all
instructions contained herein, in particularly the safety instructions. These original
operating instructions must be kept near or in the product for the lifetime of the product.
To Next Page
Loading...