4.4.4.2 Draining the Cooling System
Required material (not included in scope of delivery):
• Hose (Ø 20 mm) with sealing nipple and cap nut (M18x1.5)
• Suitable vessel (each cooling system contains approximately 45 litres)
Procedure:
1. Remove the cap nuts (Figure 75, Pos. 2 and 3)
2. Fix hose with sealing nipple on the connection (M18 x 1.5)
3. Keep at hand a suitable vessel to catch cooling fluid.
4. Bring ball valves in position ON.
5. Open tank cover.
6. Dispose cooling fluid correctly.
To Next Page
Loading...