3-12 Phaser 3250 Laser Printer Service Manual
Error Messages and Codes
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Fuser for any paper jam
inside the Fuser.
2.Is there paper in the Fuser?
Remove paper
from the Fuser.
Clean the
surface of the
Pressure Roller.
■ Roller #1
(page 8-20)
■ Roller #2
(page 8-22)
Go to step 2.
2 1.Check the Exit Sensor for damage.
2.Is the Exit Sensor damaged?
Replace the Exit
Sensor
(page 8-55).
Go to step 3.
3 1.Check the Exit Actuator for damage.
2.Is the Exit Actuator damaged?
Replace the Exit
Actuator
(page 8-54).
Go to step 4.
4 1.Check the Guide Claws for damage.
2.Are the Guide Claws damaged?
Replace the
Fuser
(page 8-13).
Complete.
To Next Page
Loading...
