Xerox Phaser 3250 - Wrong Print Position

Phaser 3250 Laser Printer Service Manual 3-17
Error Messages and Codes
Wrong Print Position
Prints begin at wrong position on the paper.
Applicable Error Message
■ Wrong Print Position
Initial Actions
■ Try picking paper from a different tray.
■ Check the paper path for obstructions or debris.
■ Cycle printer power.
■ If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Feed Actuator, PL6.1.72
■ Feed Sensor (Photo Interrupter),
PL6.1.75
■ “Map 6 - Main Motor, Interlock Switch,
Fans, and Sensors” on page 10-14
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Feed Sensor for damage.
2.Is the Feed Sensor damaged?
Replace the
Feed Sensor
(page 8-49).
Go to step 2.
2 1.Check the Feed Actuator for
damage.
2.Is the Feed Actuator damaged?
Replace the
Feed Actuator
(page 8-45).
Complete.