Xerox Phaser 3250 - Fuser Gear Does Not Function Due to Overheating; Fuser Gear Does Not Function Due to Overheat

3-22 Phaser 3250 Laser Printer Service Manual
Error Messages and Codes
Fuser Gear Does Not Function due to Overheating
There is a constant jam where paper is entering the Fuser or the Fuser
Rollers are not turning.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5 minutes
for the Fuser to cool before removing the Fuser.
Applicable Error Message
■ Fuser Gear Does Not Function due to Overheat
■ Overheat Error
■ Diagnose Overheat
Initial Actions
■ Ensure that the Fuser is secured to the printer.
■ Cycle printer power.
■ If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map Reference
■ Main Controller Board, PL1.1.2
■ LVPS, PL1.1.4
■ Fuser, PL9.1.0
■ Halogen Lamp, PL9.1.30
■ “Map 1 - Main Controller Board” on
page 10-6
■ “Map 3 - LVPS” on page 10-8
■ “Map 7 - LVPS, HVPS, Fuser, Developer
Unit CRUM, and Power Switch” on
page 10-15
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Halogen Lamp for
damage or overheating.
2.Is the Halogen Lamp damaged?
Replace the
Halogen Lamp
(
page 8-24).
Go to step 2.
2 1.Replace the Fuser (page 8-13).
2.Does the error still occur?
Replace the
LVPS
(
page 8-67).
Go to step 3.