Phaser 3250 Laser Printer Service Manual 3-15
Error Messages and Codes
Paper Empty without Indication
The LED is not lit on the Control Panel even when the paper tray is empty.
Applicable Error Message
■ Paper Empty without Indication
Initial Actions
■ Check the paper path for obstructions or debris.
■ Cycle printer power.
■ If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Main Controller Board, PL1.1.2
■ Empty Actuator, PL6.1.84
■ Paper Empty Sensor (Photo
Interrupter), PL6.1.75
■ “Map 1 - Main Controller Board” on
page 10-6
■ “Map 6 - Main Motor, Interlock Switch,
Fans, and Sensors” on page 10-14
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Empty Actuator for
damage.
2.Is the Empty Actuator damaged?
Replace the
Empty Actuator
(page 8-49).
Go to step 2.
2 1.Check the Paper Empty Sensor for
damage.
2.Is the Paper Empty Sensor
damaged?
Replace the
Paper Empty
Sensor
(page 8-51).
Go to step 3.
3 1.Check the Main Controller Board for
correct installation. Reseat the Main
Controller Board (page 8-62).
2.Does the error still occur?
Replace the
Main Controller
Board
(page 8-62).
Complete.
To Next Page
Loading...
